日本YUKEN先导式平衡阀，DSG-01-2B2-A240-70

日本YUKEN先导式平衡阀，DSG-01-2B2-A240-70

This value is measured for each valve
based on a supply pressure of 14
MPa.There are restrictions on the m
ounting position. Consult Yuken for details.
电气连接11+ PE连接器[EN175201部分804]
1）返回在DR端口压力应为0.2兆帕或更小，并不会成为负压。
2）此值被测量为基础的14兆帕的压力供给各阀。
3）上有安装位置的限制。油研咨询有关详情。
（Pres. PS =14 MPa时，粘度：32平方毫米/秒）
滞后0.1％或更少 芯行程来停止毫米±1
极性查看的I / O信号特性的描述。
直线电机电流zui大。 1.5 A
规格线圈电阻在20°C7Ω
Back pressure at the DR port should be
0.2 MPa or less and not be a negative pressure.
Linear Motor Current Max. 1.5 A
Specification Coil Resistance at 20 °C 7 Ω
Approx. Mass 9.3 kg
Electric Connection 11 + PE
Connector [EN175201 Part 804]
Rated Flow at ⊿P = 7 MPa L/min 130
Max. Operating Pres. MPa 31.5
Proof Pres. at Return Port MPa 21
DR Port Permissible Back Pres. 1) MPa 0.2 or less
Internal Leakage L/min
n about I/O signal characteristics.
(Pres. Ps = 14 MPa, Viscosity: 32 mm2/s)

日本YUKEN先导式平衡阀，DSG-01-2B2-A240-70